Request Information

Name*
Company*
Title
Street
City
State
Zip
Country
Email*
Web Site
Phone
Fax
*Required fields

Request
	Literature
	Quotation
	Would like a phone call from Bertsch Sales Department to discuss application
	Would like Bertsch sales person to arrange sales call to your company
	Service

Quotation

If you know which model(s) you would like quoted please enter the model number(s) here.

(If you would like Bertsch to quote a machine based on your application needs please enter specifications below.)

Choosing the Right Roll Size There is no standard for claiming the capacity of a bending roll. This fact creates confusion on the part of the buyer, and ultimately results in bad purchase decisions. Rolling capacity is dependent upon several factors: Thickness of the rolled part Width of the rolled part Diameter of the rolled part Material yield and tensile strength Multiple Pass vs. Single Pass Furthermore, rolling capacity and pre-bend capacity of a given machine may be different and stated separately. Even stated pre-bend capacities may be confusing since these are sometimes specified to 5 times or 10 times the top roll diameter (which may not benefit a user who wants to roll at 1.1 times or 1.5 times top roll diameter). In order to make accurate comparisons between manufacturers, the buyer must communicate appropriate application information to each manufacturer so that the correct bending roll is proposed, and a good purchase decision is made. Please fill out the following information so we can appropriately size a bending roll for your application.
Thickness
Maximum Thickness to be Rolled
Maximum Width (at Maximum Thickness)
Maximum Diameter (at Maximum Thickness)
Material Type or Grade (Maximum Thickness)
Minimum Thickness to be Rolled

Maximum Rolled Part Width
Maximum Width to be Rolled
Maximum Thickness (at Maximum Width)
Minimum Diameter (at Maximum Width)
Material Type or Grade (Maximum Thickness)

Minimum Diameter
Minimum Diameter to be Rolled
Maximum Width (at Minimum Diameter)
Maximum Thickness (at Minimum Diameter)
Material Type or Grade (Minimum Diameter)

Other Application Needs (such as Cone Rolling or CNC Controls)

(Enter all that apply)